Publicité
Onderhoud
Reinig de buitenkant van de luidsprekers enkel met een zachte en droge doek of
kwast.
U mag in geen geval agressieve schoonmaak- of chemische oplosmiddelen gebrui-
ken daar dergelijke producten het behuizingsoppervlak kunnen beschadigen.
U mag de gevoelige membranen niet aanraken!
Afvoeren
Indien de luidsprekers Control 10 niet meer werken, dient u deze volgens de gelden-
de wettelijke bepalingen voor afvalverwerking af te voeren.
Technische gegevens
Impedantie . . . . . . . . . . . . . . . . . . : 4 / 8 Ohm (afhankelijk van de aansluitklem)
Frequentiebereik . . . . . . . . . . . . . . : 90 - 20.000 Hz
Geluidsdruk (1W / 1m) . . . . . . . . . : 87 dB (+/-2 dB)
Belastbaarheid (RMS/max.) . . . . . : 40 / 100 W
26
Function description
The speakers are designed according to the closed 3-way principle.
The housing and the loudspeaker membranes are protected against moisture.
The speakers can be set up to stand or they can be mounted to a wall or ceiling via
the supplied mounting bracket.
The speaker cables are connected via terminals with an impedance value between 4
and 8 Ohm being selectable.
Commissioning
To guarantee a proper commissioning of the product, please read this
operating manual with the safety instructions completely and carefully
before using the device.
Setting up / installing the speakers
Do not place your speakers in the direct vicinity of screens such
as TV sets or PC monitors. There is the risk of the speakers' mag-
netic fields distorting the picture.
To yield the best possible sound image, please try to implement the following
instructions concerning the location of the speakers within the scope of your room's
arrangement:
• Set the speakers up in a way that the location where you intend to hear the sound
is in equal distance of both speakers (equilateral triangle).
• In rectangular rooms, the speakers should possibly be set up alongside a short
wall.
• The tweeters should be located in ear-height.
If you intend to mount the speakers via the supplied bracket, proceed as follows:
Use the mounting bracket as a stencil
and mark the attachment holes at the
mounting location.
Take care not to damage existing wire
or the like by drilling below the mounting
surface.
11
Publicité
