Lithonia Lighting TFX3 Directives D'installation page 3

Remove fi xture components and parts pack. Check to ensure all
parts are included. Note: Account for small parts and destroy packing
material, as these may be hazardous to children.
Turn OFF Power at circuit breaker box.
CAUTION: Do not rely on wall switch alone to turn off power.
IS - Slipfi tter Mounting:
Remove the coverplate to access the integral wiring compartment using
a fl at head screwdriver or 1/4" hex socket driver. Place integral slipfi tter
onto 2-3/8" diameter Tenon ensuring that the wires are pulled through
the integral wiring compartment without pinching. Secure slipfi tter to the
Tenon by tightening the 4 socket head cap set screws to 18ft-lbs. Make
supply connections through the integral wiring compartment. Refer to
wiring instructions on next page for power connection. Push wires into
compartment and re-install cover plate.
To adjust the tilt angle of the fi xture, loosen the 1/2" hex socket screw
above the integral wiring compartment. Rotate fi xture to desired angle
and re-tighten center screw to 36ft-lbs.
1/2" Hex Socket Screw
YK - Yoke Mounting:
Mount fi xture to the desired bracketry with one 5/8" or two 1/2"
fasteners, lock washer, and nut (not provided). Tighten to 30ft-lbs. See
template of yoke bracket hole pattern below.
Cover Plate
5/16" Socket Head Set
Screw
INSTALLATION INSTRUCTIONS
The Yoke Mount option is provided with 2.6ft long 18AWG power
supply cord. A UL LISTED water tight cord connector suitable for use
with wet location fl exible cord shall be required in order to install onto a
wet location outdoor junction box. See image below.
To reduce risk of water entry when installing onto an outdoor junction
box ensure that a Tefl on tape or silicone sealant is applied on the
threaded portion of the fi tting. It is recommended that the water tight
cord connector be installed so that power supply cord exits towards the
ground. If existing wiring does not allow for installation of wires exiting
towards the ground, the use of an elbow suitable for wet location use
is recommended so that cord can exit towards the ground. See images
below.
To adjust the tilt angel of the fi xture, loosen the 7/16" hex head screws
on both sides of the yoke. While holding weight of fi xture, remove 7/16"
hex head set screw, adjust to desired angle and reinstall set screw in
appropriate matching hole. Re-tighten hex head screws to secure.
7/16" Hex Head Screw
Hex Head Set Screw
CAUTION: WIRING AND FIXTURE OPERATION
Make sure power is turned off .
To Ground fi xture use Wire Nut to connect the (copper) house supply
ground wire & the (green) fi xture ground wire. Note: If house wiring
does not include a ground wire, consult your local electrical code for
approved grounding methods.
For proper connection, place wire nut over
wires and twist clockwise until tight.
To connect supply wires use Wire Nuts to connect the black fi xture wire
to the black power supply wire and the white fi xture wire to the white
(neutral) supply wire.
page 3