Ego Power+ PH1400E Mode D'emploi page 8

OPERATION
EN
WARNING:
Do not allow familiarity with this product
to make you careless. Remember that a careless fraction
of a second is sufficient to inflict serious injury.
WARNING:
Always wear eye protection. Failure to do
so could result in objects being thrown into your eyes and
other possible serious injuries.
WARNING:
Do not use any attachments or
accessories not recommended by the manufacturer of
this product. The use of attachments or accessories not
recommended can result in serious personal injury.
WARNING:
NEVER OPERATE THE POWER HEAD
WITHOUT AN ATTACHMENT.
INSTALLING/REMOVING THE BATTERY PACK
NOTE:
Fully charge the battery pack before first use.
To Install
Align the battery ribs with the mounting slots and press
the battery pack down until you hear a "click" (Fig. J).
Fig. J parts description see below:
J-1 Mounting Slot
J-2 Rib
To Remove
Depress the battery-release button and pull the battery
pack out (Fig. K).
WARNING:
To avoid serious personal injury, always
remove the bat tery pack and keep hands clear of the
lock-off button and trigger when carrying or transporting
the tool.
STARTING/STOPPING THE POWER HEAD (Fig. L)
To Start
Press down the lock-off button and hold it in that position.
Depress the trigger to turn on the power head. Different
pressure on the trigger results in variable rotating speed
of the power head. More pressure, higher speed.
To Stop
Release the trigger.
NOTICE:
The motor runs only when the lock-off button
and trigger are both pressed.
8
56 VOLT MULTI TOOL POWER HEAD — PH1400E
Speed Adjustment Function (Fig. L)
The power head has two speeds. Position"1" is for low speed
while Position "2" for high speed. Push or pull the high/low-
speed switch to choose the suitable speed during operation.
Fig. L parts description see below:
L-1 Hign/Low-Speed Switch
L-2 Lock-off Button
L-3 Trigger
MAINTENANCE
WARNING:
Before inspecting, cleaning or servicing
the unit, stop the motor, wait for all moving parts to stop, and
remove the battery pack. Failure to follow these instructions
can result in serious personal injury or property damage.
WARNING:
When servicing, use only identical
replacement parts. Use of any other parts can create a
hazard or cause product damage. To ensure safety and
reliability, all repairs, other than the items listed in these
maintenance instructions, should be performed by a
qualified service technician.
NOTICE:
Before each use, inspect the entire product
for damaged, missing, or loose parts such as screws,
nuts, bolts, caps, etc. Tighten securely all fasteners and
caps and do not operate this product until all missing or
damaged parts are replaced. Please contact customer
service or a quali fied service technician.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
CLEANING THE POWER HEAD
1. Stop the motor and remove the battery pack.
2. Clean dirt and debris from the power head using a
damp cloth with a mild detergent.
NOTICE:
Do not use any strong detergents on the plastic
housing or the handle. They can be damaged by certain
aromatic oils such as pine and lemon.