Velleman TA4 Mode D'emploi

1. Description
Nr./N° English
1 backlight button
2 front panel
3 °C/°F switch
4 in/out temperature
5 velcro tape
6 AAA-battery (1.5V)
7 back panel
8 outdoor sensor
2. Installation & Care
Mount the device in a spot protected from direct sunlight, water and extreme temperatures. Wipe the mounting area
clean, remove the protective paper from the velcro strips and press the device firmly into position.
Use a soft cloth moistened with a mild detergent to wipe the device clean. Do not use alcohol or solvents.
3. Controls
1. Press the backlight button (1 in fig.) to illuminate the LCD display for ± 3 seconds. Keep in mind that frequent
use of this button will wear down your battery.
2. Use the slide control (3 in fig.) to display the temperature in °C or °F.
3. Press the in/out button (4 in fig.) to alternately display the inside and outside temperature.
4. Battery
Remove the cover of the battery compartment, insert a new AAA-battery of 1.5V while respecting the polarity
indications inside the battery compartment and replace the cover.
TA4
TA4 – In/Out Thermometer With Backlight
Nederlands
achtergrondverlichting
frontpaneel
°C/°F schakelaar
binnen-/buitentemp. t° intér./extérieure
velcrostrip
AAA-batterij (1.5V)
achterpaneel
buitensensor
français
éclairage de fond retroiluminación
panneau frontal
comutateur °C/°F conmutador °C/°F
temperatura interior / exterior
adhésif velcro cinta de velcro
pile LR3 (1.5V) pila AAAj (1.5V)
panneau arrière panel posterior
capteur extérieur sensor exterior
1
español
Hintergrundbeleuchtung
panel frontal
Innen-/Außentemp.
Velcro-Klebepad
AAA-Batterie (1.5V)
Deutsch
Frontplatte
°C/°F-Schalter
Rückseite
Außenfühler
VELLEMAN