Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operation
Getting Started
Before using the reader, it is necessary to first fully
charge the battery pack as described in battery
management section.
Switch on / off instructions
Press and release the "SCAN" button once to turn the
reader on. At start-up, it will switch on the RED light and
beep once.
Note 1
for 2 minutes by default and then shut down
automatically emitting two beeps.
Reading a transponder
To search for tags, press and release the SCAN button.
When searching for tags, the red light will flash. The
reader will continue searching tags for 3 seconds until a
tag is found or the time is elapsed.
- Once activated, the reader will stay on
3
Publicité
Table des Matières
