Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
C H A R G I N G B A S E
WALL MOUNTABLE
The Charging Base can be mounted
vertically (see Figure A) or placed on
a horizontal surface such as a counter,
shelf, etc.
If you choose to wall mount the
Charging Base, please use the
enclosed anchors and screws. Drill
5 mm diameter holes into the wall.
Wall Mounting Base
Figure A
Charging Plug
| C H A R G I N G P R O C E D U R E
CHARGING PROCEDURE
1.Plug the Charging Base into a
230 volt electrical outlet.
2.IMPORTANT: Make sure that the
On/Off switch is turned to the
„Off" position before charging.
Otherwise, your vacuum will not
charge.
3.Slide the vacuum downward onto
the charging base making sure that
the vacuum firmly hooks onto the
Charging Base (see Figure B). The
Green Light indicates that charging
is taking place. If your DirtTamer
is completely out of power, a full
recharge will take approx. 10 h.
Note: before first use, charge your
vacuum for at least 24 hours.
4.To maintain a
charge, keep
the Charger
plugged in
at all times.
The Charger
may be warm
to the touch.
This is normal.
6
Figure B
Publicité
Table des Matières
