Stopping The Tool; Battery Charging - CAMPAGNOLA T-REX Manuel D'utilisation Et D'entretien

Do not use any recycled oil. It could damage the lubrication pump.
Before any oil supply, clean the area around the plug (12), so that no impurities may enter the reservoir (14).
After each refueling, press a few times the rubber bulb on the reservoir plug (12), so that when the tool is
started, oil is poured onto the whole chain (1). While working with the tool, press the rubber bulb according to
need and use, in order to keep the chain (1) lubricated
4.2

Stopping the tool

• Release the operating lever (7);
• Switch off the tool by means of the ON/OFF button (10);
• Remove the battery (16) by pressing the releasing plates (17).
Never put the tool onto the ground before the chain (1) has stopped its movement
Let the chain (1) and bar (2) cool for a few minutes before checking the chain (1) tension.
4.3

Battery charging

Connect the battery (16) to the battery charger (18) and the plug of the charger to the socket. Avoid using electrical
extension cables, as they are a source of electrical risks.
The battery charger LED lights (19) become red during the recharge. When the battery is charged up, the LED light
(19) becomes green.
Each recharge connector (20) has a corresponding indicator on the battery charger (18).
The batteries are charged in sequence, the one after the other, not simultaneously.
The LED light indicator (19) becomes red during the recharging operation, green when recharge is over.
Recharge of 3 connected batteries:
As soon as the first battery is charged
up (green LED light (19)), the recharge
of the second battery starts followed
by the recharge of the third one.
When recharge is over, all the LED
Lights (19) are green.
Page. 34 Use and maintenance manual – Translation of
original Instruction.: 01, Date 04/11/2021