Operating The Cordless Drill Driver - Storch DriveFixx 10,8 V Mode D'emploi

Operating the cordless drill driver

TRIGGER SWITCH (Fig. 5)
To turn the drill ON, depress the trigger switch. To turn it
OFF, release the trigger switch.
VARIABLE SPEED (Fig.5)
The variable-speed trigger switch delivers higher speed
with increased trigger pressure and lower speed with
decreased trigger pressure.
DIRECTION OF ROTATION SWITCH (FORWARDS /
SWITCH LOCK / BACKWARDS) (Fig. 5)
The direction of rotation of the bit can be reversed and is
controlled by a selector located above the trigger switch.
With the drill held in normal operating position:
Actuate the direction of rotation switch on the left of the
tool for drilling.
Actuate the direction of rotation switch on the right of the
tool for reverse motion.
To prevent the drill from being switched on accidentally
set the switch to the OFF position (switch lock, centre)
when the drill is not in use.
ATTENTION:
To prevent damaging the transmission only change the direction of rotation when the tool is at a complete
standstill.
NOTE:
The drill driver will not work if the direction of rotation switch is not engaged properly on the left or right-
hand side.
ELECTRIC BRAKE
To stop the drill, release the trigger switch and allow the chuck to come to a complete stop. The electric brake quickly
stops the chuck from rotating. This feature engages automatically when you release the trigger switch.
KEYLESS CHUCK (Fig. 6)
The drill driver has a keyless chuck to tighten or release
drill bits in the chuck jaws. The arrows on the chuck indi-
cate the direction in which to rotate the chuck body in
order to GRIP (tighten) or OPEN (release) the chuck jaws
on the drill bit.
WARNING:
Do not use the rotary motion of the drill to tig-
hten the chuck jaws around the drill bit while
holding the chuck body in one hand. The chuck
body can spin in your hand, or your hand could
slip and come into contact with the rotating
drill. This can result in an accident and serious
bodily injury.
backwards
Trigger
switch with
variable speed
control
Chuck jaws
GRIP
(tighten)
84
forwards
Direction of
rotation switch
Keyless chuck
OPEN (release)
Chuck
body