Silverline 758130 Mode D'emploi page 10

GB
Brushes
• Over time the carbon brushes inside the motor may become worn
• Excessively worn brushes may cause loss of power, intermittent failure, or visible sparking
• Regularly check the condition of the brushes and replace if worn
• Always replace both brushes at the same time. A spare pair of brushes is supplied
• If you are in any doubt over the fitting of the new brushes DO NOT attempt, instead have the
repair carried out at an authorised Silverline service centre
To replace the brushes:
1. Unscrew the two motor cover screws and remove the Motor Cover (18) (Fig. X)
2. Slide the brush housing out of the tool. (Fig. XI)
3. Disconnect the electrical connection from the brush (Fig. XII)
4. Remove the brush from the housing and replace with a new brush (Fig. XIII)
5. Refit brush housing to tool
6. Repeat for second brush
7. Refit Motor Cover
Contact
For technical or repair service advice, please contact the helpline on (+44) 1935 382 222
Web: silverlinetools.com/en-GB/Support
Address:
Powerbox
Boundary Way
Lufton Trading Estate
Yeovil, Somerset
BA22 8HZ, United Kingdom
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools that are no longer functional
and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE), with
household waste
• Contact your local waste disposal authority for information on the correct way to dispose of power
tools and batteries
10