Corradi ERMETIKA Manuel Utilisateur page 25

® ®
Ermetika , Ermetika XL
HOW TO PROCEED IF ANEMOS AWNING FAILS TO RELEASE (MANUAL AND MOTORISED)
A B C "Y"
D
LATCH
DIS-INSERTION
"X"
LATCH
INSERTION
Electric canvas operation/manual latch operation
- Adjusting the motor limit stops: lower limit stop = few cm below guide locks.
- (A) Run the motor in descent until the terminal reaches the lower limit stop; move the latches across against the guides and lock them by tightening the knobs slightly (Callout X).
- (B) Press the up button: the motor stops automatically at the suitable tension.
- (C) To release the awning, press the descent button to loosen the canvas; dis-insert the latches by moving them away from the guides (Callout Y) nd lock them by tightening the knobs slightly .
- (D) Press the up button to wind up the awning.
Rev.13 - 09.2018 CORRADI SRL - USER MANUAL 7 of 16