Publicité
Les langues disponibles
Les langues disponibles
English
Material included with item n° :
Installation of the tool
1.
Open-end wrench SW : 16
2.
Wrench for ER16
3.
Screw support plate
4.
3x Screw M3 x 25
5.
4x Screw M5 x 20 à tête réduite
6.
3x Screw M6 x 25
7.
3x Slice M6
8.
Centering tube
Note :
This tool can be use without coolant
All fixing screws shall be tightened to the torques
specified in the table below.
Standard quality :
8.8
Recommended torque for screws and bolts
Diameter
Class 5.8
M2
0.22
M3
0.77
M4
1.8
M5
3.6
M6
6.1
M8
15
Fixation of the chuck
1. Before attaching the plate to the
machine, insert the centering tool and
the 2 M3 screws onto the plate and
tighten.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Operating instructions
BO26-RSA-210ML-3x
BRC 421 210 16
7113.16000
873-728-16
D912-M3x25
SBB5-M5x20
D912-M6x25
D125A-M06
873-019-186
Tightening torque [Nm]
Class 8.8
Class 10.9
Class 12.9
0.35
0.49
0.58
1.2
1.7
2.1
2.9
4
4.9
5.7
8.1
9.7
9.8
14
17
24
33
40
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Mode d'emploi
Betriebsanleitung
2. Center the plate on the T11 position of
the machine with the centering tool and
the pin on the back. Then tighten the 4
M5 screws.
3. Once the plate is fixed and centered,
remove the centering tool with the 2 M3
screws.
4. Insert the tool holder on the plate by
centering it with the tail and tighten the 6
screws (M3 and M6) as well as the
washers in the desired angular position.
5. When mounting or disassembling your
cutting tools, block the pin on the plates
provided for this purpose and loosen the
nut using the keys provided.
NOTE :
Never use the tool holder with
empty positions.
Garant:
BO26-RSA-210ML-
BT
Validation : 27.09.2019
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email:
office@pcm.ch
Document :
3x Mode d'emploi
Page : 2 de 3
Publicité
