Publicité
Les langues disponibles
Les langues disponibles
OPERATION
Control panel
High
Mid
Swing
Cool
Low
Remote control
Note: Remote control operation function is same as the control
panel on unit.
Install one CR2025 lithium button battery (include).
Power "
1.
"
Press this button to turn on the unit, press it again to turn off the unit. (the fan
with memory function and working at last setting, except "Timer")
2.
Timer "
"
It can be set between 1 to 8 hours, increased by 1 hour intervals.
3.
Mode "
"
Press this button to select desired wind mode, NORMAL→NATURE→SLEEP→
NORMAL, in turn. The corresponding wind mode indicator will be displayed.
Speed "
4.
"
Press this button to select desired fan speed, LOW→MID→HIGH→LOW, can be
adjust the fan speed in "normal" mode use only.
5.
Swing "
"
Press this button for Fan Oscillation with left and right direction, press it again
to stop, and you can also adjust the fan's up and down direction by hands.
6.
Cooler "
"
Press this button to turn on/off the cooling function.
Note: Before acting this function, be sure to fill enough water into the water
tank.
Sleep
8H
4H
Nat.
2H
Nor.
1H
Power
SPEED
TIMER
(Fig. 1)
CLEANING AND MAINTENANCE
Maintenance:
Dry the honeycomb after using to avoid mildew;
1.
Replace and cleaning the water regularly to keep
2.
water clean.
Use a dry cloth to absorb remaining water inside the
3.
tank, and dry it using a piece of soft cloth;
Pack this appliance properly and store it in a cool dry
4.
place if it is not to be used for a long period of time.
POWER
Cleaning:
MODE
Unplug the unit before cleaning.
1.
Remove the rear net first.
SWING
2.
COOL
Take out the honeycomb and clean it with the rear net.
3.
Clean the water tank and the top flume at the same
4.
time.
Caution:
Use soft cloth and liquid for cleaning.
1.
Any part of control panel cannot be stained with water.
2.
50 | 51
GB
Publicité
