Toolland DT20016N Mode D'emploi page 5

5. Assembly
5.1 Assembling the Tank
Right-Handed Operation
1. Remove the pump cap, pull out the complete pump system and fix the mixer with the clip.
Reassemble.
2. Slide the pump lever into the opening on the bottom side, at the same side as the pump's.
Turn the lever until the hole appears. Fix the lever with the large plastic clip, making sure
the pin of the clip clicks into the hole.
3. Fix the second large gasket onto the visible part of the rod. Fix the rod using a large gasket
and split pin.
4. Slide the upper end of the pump rod into the connection of the pump. Fix with a gasket and
a split pin.
5. Slide the lower end of the pump rod into the connection on the pump lever. Fix with a
small gasket and a split pin.
6. Fix the harness onto the tank. Make sure to hand-tighten both the pump cap and filling
cap.
Left-Handed Operation
The pump can also be mounted for left-handed use. Simply reverse the position of the pump
and hose connection, follow the mounting instructions as per above and fix the harness to the
front of the tank.
5.2 Mounting the Lance
1. Slide a nut and little gasket onto both ends of the lance tube.
2. Connect the required nozzle onto one end of the lance tube. Connect the other end to the
control valve.
3. Slide the filter inside the control valve and connect to the hose. Connect the other end of
the hose to the hose connection on the tank.
6. Operation
1. Ensure that the backpack sprayer is correctly mounted. Fill the tank with the required liquid
and hand-tighten the filling cap.
2. Operate the pump lever to pressurize the tank.
3. To spray:
Intermittent operation: Depress the trigger on the control valve to operate and release
o
it to stop spraying.
Continuous operation: Depress the trigger and lock it on the control valve. Pump to re-
o
pressurize the tank. Unlock and release the trigger to stop spraying.
V. 01 – 18/10/2021
DT20016N
5 ©Velleman Group nv