HQ Power VDPDP1-2 Notice D'emploi page 4

4. Description
a) Front panel
1. Output (6A max.)
2. Display (current state for adjustment)
3. Menu button (function selection)
4. Up button
5. Down button
b) Rear panel
1. Power cord
2. Fuse (F6.3A 250V 5x20mm)
3. DMX in (3-pin male XLR socket)
4. DMX out (3-pin female XLR socket)
5. Installing the Device
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
• The carrying construction must be able to support 10 times the weight of the device for 1 hour without deforming.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified technician
check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorized persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install the
device yourself if you lack these qualifications as improper installation may result in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 0.5m radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
6. Operation
a) Assigning DMX address (A)
1. The segment display shows the last DMX address used. If you've select address 1, then the
display segment will show 1.
2. Each tap of the UP or DOWN button will change the address once. Press and hold the button
to change quickly. Once the required address has been selected, it will automatically be stored
into the memory.
NOTE: During DMX addressing, the output is DISABLED.
VDPDP1-2_v2 4 HQ POWER™