OPERATION
Note: For best performance, please fully charge the cornea remover
before use.
1. Remove the protective cap from the machine.
2. Press and hold the multifunction key for two seconds to switch on
the machine. The indicator lamp lights up green.
3. The cornea remover has two speeds. The normal speed is preset
when the machine is switched on. Press the multifunction button
again to switch between the strength levels.
4. Hold the cornea remover firmly in your hand and gently guide
the polishing wheel over the dead skin areas and slowly move it
outwards towards the healthy skin.
5. To switch off the unit, press and hold the multifunction key for two
seconds until the indicator lamp goes out.
1
Note: To avoid injury to healthy skin, use the cornea remover only on
dead skin areas.
CHANGING THE POLISHING DISCS
Lock both ends of the disc lever at the edges of the
polishing disc and lift it to the side.
4
16