Elesa DD52R-E-RF Mode D'emploi page 16

DD52R-E-RF
1. Safety Instructions
The product has been designed and manufactured in accordance with the current
regulations. The product leaves the factory ready for use and complies with the
safety standards.
To maintain the product in this state, it is necessary that it is assembled and
used properly, in the closest compliance with this instruction manual and with the
following specific safety precautions.
Ensure that the user has read and understood the instruction manual and in
particular the chapter "Safety Instructions".
In addition to the instruction manual, all the rules of law must be observed, in
regard to accident prevention and environmental protection.
This manual is intended as an indispensable supplement to the existing
documentation (catalogues, data sheets and assembly instructions).
Do not open nor modify the case of the indicator.
Tampering with this product may endanger the correctness and accuracy of its
operation. In case of malfunction, do not attempt any repairs to the units and
contact Elesa sales office.
2. System description
DD52R-E-RF, position indicators, with battery power supply, can be used on
passing through shafts in any position to provide the reading of the absolute or
incremental positioning of a machine component.
DD52R-E-RF postion indicators must be connected to UC-RF control unit via radio
frequency network.
PLC
EN
16
The use without complying with the descriptions / specific
parameters, in combination with systems / machines /
processes to be controlled, it can lead to a malfunction of the
product, causing:
- health hazards,
- environmental hazards,
- damage to the product and its proper functionality.
Electronic position indicators
Data transmission via radio frequency
Target positions
Current positions
Models all rights reserved in accordance with the law.
Always mention the source when reproducing our drawings.
Up to 36