If you want to switch off the system, switch off the amplifier first and then the pre-amplifiers in order to
avoid acoustic shocks on the speakers.
PROBLEM CHART
PROBLEM:
No power.
No sound.
Noise.
Fan does not work, LEDs
do not light up
Protect
LED
lights
permanently
CLEANING AND MAINTENANCE
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no servicable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.
Replacing the fuse
If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Please note: This fuse is being used for both 115 V and 230 V.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuseholder on the rearpanel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
CAUSE:
• The power-cord is not connected.
• The power-cord of the respective
device is not connected properly or
not connected at all.
• The connection-socket or the plug is
dirty.
• The input-signal is too strong.
• The power-cord is not connected.
up
• Inputs receive DC-voltage.
• Amplifier is overheated due to
impurities.
• Impedance of speakers too low
• Short-circuit in speaker connection or
in speakers
• Technical default of amplifier
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
• Check the power-cord and any
extension-cables.
• Check the power-cord and if the
plugs are tightly connected with the
sockets.
• Clean the socket and/or the plug.
• Reduce the input-signal via the Gain-
control.
Please check if the power is available
• Switch amplifier off and have the
device
technician.
• Clean the fan-grille.
• Connect other speakers.
• Check speakers.
• Switch amplifier off and have the
device
technician.
30/49
REMEDY:
checked
by
a
service-
checked
by
a
service-
00008423.DOC VERSION 3.2