Rear Panel - Omnitronic LXO-230 Mode D'emploi

(7) MUTE-BUTTON
Via the Mute-button, the respective channel can be muted.
(8) DELAY-CONTROL
Via the Delay-control you can adjust the delay time of the respective output signal.
(9) CROSSOVER FREQUENCY-CONTROL
Via the crossover frequency-control you can adjust the crossover frequency between the respective
signal portions.
(10) x10-LED
The x10-LED lights up when the adjustable frequency range is at 800-8000 Hz.
(11) x1-LED
The x1-LED lights up when the adjustable frequency range is at 80-800 Hz.
(12) RANGE-BUTTON
Via the Range-button, you can switch the frequency range between 80-800 and 800-8000 Hz.
(13) MONO-LED
The Mono-LED lights up when the LXO-230 is in mono-mode.
(14) STEREO-LED
The Stereo-LED lights up when the LXO-230 is in stereo-mode.
(15) Sub ∑-LED
The Sub ∑-LED lights up when the Sub ∑-function is activated.
(16) HORN EQ-BUTTON
Via the Horn EQ-button, the Horn EQ-function can be activated.
(17) HORN EQ-LED
The Horn EQ-LED lights up when the Horn EQ-function is activated.
(18) LOW CUT-BUTTON
Via the Low Cut-button, the Low Cut-function can be activated.
(19) LOW CUT-LED
The Low Cut-LED lights up when the Low Cut-function is activated.
(20) LIMITER-BUTTON
Via the Limiter-button, the limiter can be activated.
(21) LIMITER-LED
The Limiter-LED lights up when the limiter is activated.
(22) TRESHOLD-CONTROL
Via the Threshold-control, you can adjust the Limiter-threshold of all four limiters between -6 dBU and
+18 dBU.

Rear panel:

(23) AC-CONNECTION
Used to plug the power-cord in.
(24) FUSEHOLDER
Only replace the fuse when the device is disconnected from mains. Only use fuses of the same rating
and power.
(25) POWER SWITCH
Press this button to start operation.
(26) OUTPUT SOCKET
Output socket for connecting the respective power amplifier.
ø
(27) -BUTTON
ø
Via the -button, the phase invert for the respective channel can be activated.
(28) INPUT SOCKET
Input socket for connecting the respective signal source.
20/38 10304060_V_1_0.DOC