Würth RW 1010 Traduction Des Instructions De Service D'origine page 9

GB
Please read this instruction manual
before using the device for the first
time and comply with it.
Retain this instruction manual for
future reference or for subsequent
owners.
Note
It is not allowed to modify the device
or to manufacture additional tools.
Such modifications can cause injuries
and malfunctions.
Only authorised and trained personnel are al-
■
lowed to repair the device. Only use genuine
spare parts from Adolf Würth GmbH & Co.
KG. This ensures continuous device safety.
Adhere to the following safety instruc-
tions during operation
Always wear safety glasses, hearing
protection, protective gloves and face
mask.
Before each use, check the device, cables
■
and plugs. Have faults and defects repaired
by qualified technicians only. Only plug in the
power cord when the machine is switched off.
If the mains lead is damaged or severed
■
while working, do not touch the cable and
immediately unplug the device. Never use the
appliance when the power cord is damaged.
For your safety
Failure to adhere to this instruction manual and
the safety instructions may result in damage to
the device and cause dangerous situations for the
operator and other people.
In case of transport damage inform your vendor
immediately.
Safety instructions
Protect the electronic device from rain or
■
moisture. If water enters the electronic device,
there is an increased risk of electric shock.
When working outside use only extension
■
cords which are suitable for outdoor use.
Using a suitable cord minimizes the risk of
electric shock.
The mains voltage must conform with the
■
voltage specified on the name plate.
Always hold the nailer firmly in both hands
■
when working with it and ensure you work on
stable ground.
Hold the power tool by the insulated gripping
■
surfaces, when performing an operation
where the cutting accessory may contact
hidden wiring or its own cord. Cutting
accessory contacting a "live" wire may make
exposed metal parts of the power tool "live"
and could give the operator an electric shock.
Check that the stirring attachment is locked
■
into place and rotates easily.
WARNING – Prior to the first
start-up, it is definitely necessary to
read the Safety instructions!
Do not operate the device in an
environment with a potentially
explosive atmosphere. Do not add
flammable solvents or solvent-based
agents with a flashpoint below 21°C
to the mix.
9