Kampa Sizzle Notice D'utilisation page 10

Inserting the gas cartridge
WARNING! Explosion hazard
Check that the seal (fig. 2 4. A, page 4)
is in place and in good condition.
1. Proceed as shown (fig. 3, page 4).
2. Do not use excessive force. If the cartridge
lock lever will not push down, check the posi-
tion of the notch (fig. 3 4. B, page 4).
3. If you hear a hissing noise, the gas cartridge
has not been fitted correctly. Release the car-
tridge lock lever and reposition the cartridge.
Igniting the product
WARNING! Health hazard
Do not leave the product unattended
while in use.
1. Proceed as shown (fig. 4, page 4).
2. If the burner does not ignite, repeat the
ignition.
Removing the gas cartridge
WARNING! Health hazard
• Do not transport or store the product
with the gas cartridge inserted.
• Remove the gas cartridge in a well-
ventilated location.
• Ensure that there are no naked flames
in the vicinity.
• Only remove the gas cartridge when
the product is switched off and has
cooled down.
The cartridge may be disconnected even if some
gas remains.
1. Proceed as shown (fig. 5, page 5).
2. Check the content of a cartridge by shaking
and listening for the liquid gas.
3. Refit the protective cap and store the gas car-
tridge in a cool, dry, well ventilated place out
of the reach of children.
4. Check the condition of the seal (fig. 4 4. A,
page 4). Let the seal be replaced by a qualified
person if material is brittle or porous.
10
Moving and storing the product
WARNING! Health hazard
Do not transport or store the device with
the gas cartridge inserted.
Proceed as follows:
1. Turn off the product.
2. Let the product cool down completely.
3. Remove the gas cartridge from the product
(see chapter "Removing the gas cartridge" on
page 10).
4. Clean the product (see chapter "Cleaning and
maintenance" on page 10).
5. Store the device on a level, stable place out of
the reach of children.
Cleaning and maintenance
Clean the product after each use:
1. Ensure the product is cold.
2. Remove the gas cartridge from the product.
3. Wash the surfaces of the product with hot
soapy water (fig. 6, page 6).
4. Periodically check the burner to see it is free of
dirt like insects or food remains. Use a brush to
clean it.
Troubleshooting
Fault
No gas
No ignition
4445103367
Solution
Check whether the gas cartridge
was inserted properly.
Gas cartridge is empty (Test by shak-
ing the cartridge).
Outside temperature is below 4 °C,
move to warmer surroundings.
Clean the burner head with a brush.