FUXTEC FX-WB Mode D'emploi Original page 17

Original Manual 5in1 Workbench FX-WB de_en_fr_ita_rev1
2. Put one gasket on the screw hole and secure the screw by using a screwdriver.
3. Rotate the caster to fix the 4 screws, make sure the casters are fully secured.
4. Follow steps 1-3 to assemble the other 3 casters, then your car creeper is ready
to go.
5. Connect a pulling rope to the towing hole, then the dolly is completed.
TIP : How to install the casters
The 4 casters are packed in the back of the workbench and need to be installed by
the consumer after purchase. During installation, please be aware of the following:
17