DeLonghi KENDRA ELETTRICO ANTRACITE Mode D'emploi page 51

modes the temperature setting is displayed.
The entry into "Standby" mode is signalled by means of a
double beep, the exit from "Standby" mode by means of a
long beep.
4.2 OPERaTING mODES
The appliance provides 5 operating modes
which allow the user to heat the environment
in the most suitable way with respect to his
needs. Press the "Mode" selection key to select
the desired operating mode. An icon on the
LCD will show the selected operating mode.
Pilot Wire
Night/Eco
Chrono
PiLoT Wire
The temperature depends on the "Pilot Wire" com-
mand.
All "Pilot Wire" commands are enabled.
CoMForT
The "Comfort" temperature corresponds to the
temperature desired by the user.
All "Pilot Wire" commands are disabled.
niGHT/eCo
The "Night/Eco" mode keeps a comfortable tem-
perature with a reduced energy consumption.
All "Pilot Wire" commands are disabled.
AnTi-Freeze
In the "Anti-freeze" mode the temperature set
point is fixed at 7 °C.
The appliance starts heating automatically when
the room temperature drops below 7 °C.
All "Pilot Wire" commands are disabled.
CHrono
In "Chrono" mode, you can set different tempera-
tures ("Comfort" and "Night/Eco") over a 24 hour
period for each day of the week.
All "Pilot Wire" commands are disabled.
When the icon
ting element is on.
Comfort
Anti-freeze
is displayed on the LCD, the hea-
4.2.1 PILOT WIRE
To activate the "Pilot Wire" mode:
Press the "Mode" selection key until the icon
appears on the LCD.
Users can only set the "Comfort" temperature
on the appliance.
Select the desired temperature set point by
using the "+" and "-" keys.
The home must be fitted with an automation system
supporting this type of technology. In this case, correct
transmission of the programming commands can be verified
using the following diagram according to the mode set:
Night/Eco
Mode Comfort (Comfort
-3,5 °C)
Signal to be
transmitted
Voltage
between
Pilot Wire 0 volt 230 volt
and neutral
wires
The temperature displayed is always the "Comfort" tempera-
ture, regardless of the currently selected "Pilot Wire" mode.
If the Pilot Wire programmer is not connected, "Comfort"
operating mode is selected automatically.
4.2.2 cOmFORT
The "Comfort" temperature set point is the temperature
desired by the user.
Press the "Mode" selection key until the icon
appears on the LCD.
Select the desired temperature set point by
using the "+" and "-" keys.
The temperature can be choosen in the
interval between 7 °C and 32 °C.
47
Comfort Comfort
Anti-freeze Standby
-1 °C
230 volt 230 volt
115 volt 115 volt For an
Negative Positive interval interval
of 3 s
EN
-2 °C
For an
of 7 s