RF Avtek Mode D'emploi page 4

I. Function Characteristics
II. Parameters
Model No Power Input
AC120V 60Hz
AC202-04
AC230V 50Hz
III. Installation and Connection
Signal Light
Program Setting Button
Up Button
Stop Button
Down Button
This receiver is compatible with all tubular motor, cabling arrangements are shown in the diagram above. Respect the electrical
standards in force as well as the following points:
Install the Receiver with cables entry pointing downwards to avoid water infiltration. Do no install the Receiver against or sheltered
by a metallic part(it could affect the radio transmission).
Minimum distance between the Receiver and the floor: 150CM
Minimum distance between the Receiver and the roof: 30CM
Minimum distance between the Receiver and the Transmitter: 30CM
Minimum distance between two Receiver: 20CM
Do not forget to connect the earth line.
Disconnect the main supply before carrying out any work.
Be careful to avoid static electricity which could damage some electronic components.
Use flexible cables.
Ensure that no longitudinal forces act on the cable carriers after installation.
Avtek RF Module
AC202-04
Temperature Frequency
o o
433.92MHz
-40 C~+85 C
4
Receive can connect manual switch
Strong anti-jamming
Safety protection when supply power, the time of power
output is 4 min
Portable installation
Remote transmitter (RF)
Power Transmitter Power
≤ 300W ≤ 10mW
Sensitivity Operate Type
-110dBm Remote/Manual
Power Input
Motor
Diagram 1