Dometic ACX3 Série Notice D'utilisation page 21

ACX3
6.2 Using the cooler in DC mode
Proceed as follows (fig. 6, page 5):
➤ Place the cooler on a firm, level surface.
➤ Plug the DC connection cable (fig. 2 1, page 3 and fig. 3 1, page 4) into the
DC socket in the vehicle.
✔ The cooler starts cooling the interior.
➤ Pull out the DC connection cable to switch off the cooler.
6.3 Connecting to vehicle power
I
NOTE
If you connect the cooling device to the vehicle power, remember that
you may have to turn on the ignition to supply it with power.
6.4 Using the cooler in AC mode
Proceed as follows (fig. 7, page 6):
➤ Place the cooler on a firm, level surface.
➤ Plug the AC connection cable (fig. 2 2, page 3 and fig. 3 2, page 4) into the
AC mains.
➤ Turn the cooling level controller (fig. 4 1, page 4 and fig. 5 1, page 5) to the
required position.
✔ The cooler starts cooling the interior.
6.5 Connecting the cooler to a gas supply
!
WARNING!
• Never check for leaks with an open flame or near sources of ignition.
• Only use approved hose lines (DIN 4815, part 2) with a maximum
length of 1.5 m.
EN
Operation
21