Operating Modes; Programming New Cats; Normal Mode - Petporte Smart flap Guide D'utilisateur

Operating Modes

PROGRAMMING NEW CATS INTO THE SMART FLAP
Because your Smart Flap is initially supplied unprogrammed, when it is first powered
both the green and red lights will flash to indicate that there are no animals
programmed in. The door locks will also open, allowing free access for any animal to
enter or exit. Prior to installing your Smart Flap to a door or wall we advise that you
test the Smart Flap's operation by programming your cats, as shown below.
When programming the Smart Flap with an animal for the first time, ensure that
your pet is nearby as you have 30 seconds in which to introduce the animal to the
scanner. (You may wish to enlist the help of another person, as cats are naturally
suspicious of anything new!)
Press and hold the Green Button for about 10 seconds until the green light stays
illuminated and then release the Green Button. A beep should sound and the red
light should stop flashing with only the green light left flashing. You now have 30
seconds to move the porch part of the Smart Flap over your cat. There is no need to
post the cat through the Smart Flap as this can lead to unnecessary stress for the
animal. Microchips are normally implanted between the shoulder blades of the
animal; it is that part of the animal that needs to be under the porch area in order to
program the unique identification number for that animal. Once the microchip has
been successfully scanned, the Smart Flap will beep three times. The green light will
stop flashing, and the green lock will come up to its locked position.
If this procedure fails the first time, simply repeat the process.
You will need to program the unit with each of your cats by using this method. Your
Pet Porte Smart Flap can be programmed with up to 31 animals

Normal Mode:

This is the default mode on powering the cat flap and will allow only your cat(s) to
enter.
operating modes 9