Layout And Items Supplied - Pattfield Ergo Tools PE-ALB 36 Li Basic Traduction De La Notice Originale

charger in a car that is parked in the sunshine.
6. Protect batteries from overheating. Over-
loads, over-charging and exposure to direct
sunlight will result in overheating and cell
damage. Never charge or work with batteries
which have been overheated – replace them
immediately if possible.
7. Storage of batteries, battery chargers
and cordless tools. Store the charger and
your cordless tool only in dry places with an
ambient temperature of 10-40°C. Store your
lithium-ion battery pack in a cool, dry place at
a temperature of 10-20°C. Protect them from
humidity and direct sunlight. Only place fully
charged batteries in storage (charged at least
40%).
8. Prevent the lithium-ion battery pack from free-
zing. Battery packs which were stored below
0°C for more than 60 minutes must be dispo-
sed of.
9. When handling batteries beware of electrosta-
tic charge: Electrostatic discharges cause da-
mage of the electronic protection system and
the battery cells. Avoid electrostatic charging
and never touch the battery poles.
Additional safety instructions
•
Always walk. Never run.
•
Always keep the ventilation opening clean.
•
Never direct the blow hole at persons or ani-
mals.
•
The machine may only be used at reasonable
times of the day, i.e. not in the early morning
or late evening when it will be a nuisance to
other people. The times specified by local au-
thorities must be observed.
•
Remove all foreign objects with a rake and
brush before starting any blowing work.
•
Where conditions are dusty, dampen the sur-
face a little or use a sprinkler attachment.
•
Use the full-length blower nozzle extension
so that the air current can work near to the
ground.
•
Watch out for children, pets, open windows
etc. and blow the foreign objects safely away
from them.
•
Warning: This machine is not designed for
use by children.
•
Warning: Risk of injury from rotating parts.
•
Warning: Never use this equipment near
open windows.
Anl_PE_ALB_36_Li_Basic_SPK7.indb 103 Anl_PE_ALB_36_Li_Basic_SPK7.indb 103
GB
Explanation of the warning signs on the
equipment (see Fig. 7)
1. Read the directions for use before operating
the tool.
2. Do not use the tool in rain or snow. Do not ex-
pose the tool to wet conditions.
3. Keep all other persons away from the danger
zone.
4. Wear goggles and ear muff s.
5. Safety class III / Safety extra-low voltage
6. Store the battery only in dry rooms with an
ambient temperature of +10°C to +40°C.
Place only charged batteries in storage (char-
ged at least 40%).
7. Safety class II
8. For use in dry rooms only.

2. Layout and items supplied

2.1 Layout (Fig. 1/2)
1. Blower tube
2. On/Off switch
3. Engine unit
4. Harness
5. Turbo switch
6. Speed controller
2.2 Items supplied
Please check that the article is complete as spe-
cifi ed in the scope of delivery. If parts are missing,
please contact our service center or the nearest
branch of the DIY store where you made your
purchase at the latest within 5 work days after
purchasing the article and upon presentation of
a valid bill of purchase. Also, refer to the warranty
table in the warranty provisions at the end of the
operating instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
- 103 -
23.11.2017 10:06:27 23.11.2017 10:06:27