Inforad M-1 Guide De Démarrage Rapide page 7

(b) Installing the GPS antenna (3) :
The GPS antenna is a critical component for the operation of your INFORAD.
It captures the satellite signals that position your vehicle. Without it, your
INFORAD cannot function. If it is poorly fitted, it will impair the performance of
satellite signal capture, so mount it with care. The GPS antenna works by line
of sight to a network of satellites in orbit above the earth's atmosphere. This
means that it must be installed where obstacles cannot block this line of sight.
The rear and front mud guards of your bike are good places. The antenna
uses a special adhesive compound resistant to water for mounting purposes.
Remove the protective film and apply the antenna to a dry and clean surface
pressing firmly for several seconds
N.B. For security reasons, never leave the antenna cable hanging where it
may come into contact with the wheels or moving parts of your vehicle.
(c) Installing the LED warning lamp (4) :
The flexible LED warning lamp advises you of approaching danger zones by
flashing green, orange or red. It needs to be fitted within clear view of the rider
field of vision, preferablely on the front forks or handlebars by means of the
supplied plastic mounting strips (see diagramme below).
N.B. For security reasons, never leave cables hanging where they may come into
contact with the wheels or moving parts of your vehicle.
© INFORAD Ltd 2005 - Quick Start guide v1.2
GB
5