Denver CRP-514 Mode D'emploi page 3

POWER CONNECTION
Plug the AC power cord to a household outlet AC source. This unit is equipped
with a battery back up system, it requires a 3V CR2032 flat lithium battery
(not included). Insert the battery in the battery compartment, making certain
that the positive and negative (+ and -) battery terminals are attached to the
corresponding terminals on the plate in the battery compartment. If an AC power
failure occurs, the clock automatically switches to the battery power supply, the
clock and timer memory continue running. When the AC power resumes, the
clock switches back to AC again.
TIME AND CALENDAR MANUAL SETTING
Setting Time and Calendar
Press SET/MEM/M+ (11) button in standby mode and keep depress over 2
seconds to enter time set mode, after enter the setting mode, press SET/MEM/
M+ button (11) to change the mode cycle as follows:
Normal → Year → Month → Day → 12/24 H format → Real time Hour → Real
time Min → Normal
Action (during data adjustment):
- Press << / Tune - button (2) to adjust data backward.
- Press >> / Tune + button (6) to adjust data forward.
- Keep depressed << or >> button for 2 seconds to enable auto forward.
- Use SET/MEM/M+ (11) button to confirm each setting.
ALARM SETTING
Setting Alarm 1 and Alarm 2
In standby mode, press the AL1 (1) or AL 2 (7) button once to preview the alarm
time.The alarm time is displayed, press & hold the AL1 / AL2 buttons for 3
seconds and the hours will blink. Press AL1 / AL2 button (1/7) and keep depress
over 2 seconds to enter alarm set mode. Once in the setting mode, press alarm
set button (1/7) to change the mode cycle as follows:
Normal → AL 1 Hour → AL 1 Min → AL 1 weekday Alarm → AL 1 wake beep →
AL 1 wake radio → AL 1 wake radio volume →Normal.
Normal → AL 2 Hour → AL 2 Min → AL 2 weekday Alarm → AL 2 wake beep →
AL 2 wake radio → AL 2 wake radio volume →Normal.
Select alarm weekday mode as follows:
1-5: Monday to Friday
1-7: Whole week
6-7: Saturday & Sunday
1-1: One day of week
ENG-2