Electrical Connection - Baumer CleverLevel LBFH/I Manuel De Mise En Service

5.3 Approvals
The EHEDG certificate is only valid in connection with the appropriate installation parts.
These are marked with the "EHEDG Certified" logo.
The 3-A Sanitary Standard requirements are only met with the appropriate installation parts.
These are marked with the 3-A logo.
Approved for explosion hazard areas when installed as specified.
Approved by Underwriter Laboratories (UL) for use in the USA and Canada as an industrial
control device.
WHG certified for leakage and overfill protection. All documentation must be available at the
WHG
place of use and can be found on the product page on www.baumer.com
For more information about approvals and certification, please see the product page on www.baumer.com.
6.

Electrical connection

9 A voltage supply of 8 V to 36 V DC is provided.
Switch off supply voltage.
f „
Connect sensor in accordance with the pin
f „
assignment.
Output type Equivalent circuit with IO-Link
PNP
NPN
Digital (push-
pull)
www.baumer.com
Level measurement
CleverLevel
Point level detection - hygienic/industrial
Function
+ Vs
SW1
SW2
GND (0 V)
+ Vs
SW1
SW2
GND (0 V)
+ Vs
SW1
SW2
GND (0 V)
Operating Instructions
LBFH/I
®
Terminal assignment
4 3
1 2
M12, 4 pin
1
4
2
3
1
4
2
3
1
4
2
3
7 / 48