Publicité
Les langues disponibles
Les langues disponibles
scie exaRk suR BatteRie «ec 18V»
exakt «ec 18V» coRdless saW
ZaaG exakt Met BatteRiJ «ec 18V»
GB
Clamping
It is not normally necessary to clamp the material being cut as long as it is fully supported on
a work surface and held with one hand. Clamping should be used where;
• The operator is inexperienced in the use of power saws or weak handed
• Small parts or tough material is to be cut.
Cutting Limitations
There is no limitation on the size of material that can be cut as long as it is fully supported.
The saw will cut up to 12 mm deep. Material up to twice as thick can be cut if cutting is
performed on both sides.
Battery Changing and Charging
1. Plug the charger into the mains and await green LED, signalling ready status.
2. Remove the battery from the Saw (Diagram K) and slide it onto the charger, ensuring that
it engages fully (Diagram L).
3. Refer to Diagram M – When battery is attached to the charger:
a. An illuminated Red LED on the charger indicates that the battery is charging.
b. An illuminated Green LED on the charger indicates that the battery is fully charged.
c. When the Green LED on the charger and the Red LED on the battery are illuminated, the
battery is in a cool-down period and will recharge when ready. Note: Leave the battery on
the charger during this standby phase.
4. Normally the battery will start to charge immediately and will continue to charge for ap-
proximately one hour. Note: Under heavy use and/or in warm conditions the battery may
enter the standby period before starting to charge (as '3c. ' Above).
5. When the battery is fully charged, switch the charger off at the mains and remove the bat-
tery from the charger by pressing the button on the side and sliding out.
Holding and Switching On
Holding the tool correctly will result in easier and safer operation, with less fatigue.
Right handed operator: (Diagram F)
1. Grasp the handle firmly with the right hand so that it feels comfortable. The thumb should
be towards the rear of the power switch.
2. Do not cover any of the front vents and no more than one rear vent.
3. To operate, ensure that any part of the thumb between the tip and middle joint is over
the serrated area of the switch. (Whichever part is most comfortable) Squeeze the switch in
towards the handle and then pull backwards.
Left handed operator:
4. Grasp the handle firmly with the left hand so that it feels comfortable. The forefinger
should be towards the rear of the power switch.
5. Do not cover any of the front vents and no more than one rear vent.
6. To operate, ensure that any part of the forefinger between the tip and middle joint is over
the serrated area of the switch. (Whichever part is most comfortable) Squeeze the switch in
4
www.romus.fr
Réf 93690
©
Precision Tools Ltd. 2013
18
Publicité
