Publicité
Les langues disponibles
Les langues disponibles
scie exaRk suR BatteRie «ec 18V»
exakt «ec 18V» coRdless saW
ZaaG exakt Met BatteRiJ «ec 18V»
EC 18V Safety Warnings: Operating Instructions
This tool should always be used with the dust bag fitted
Setting the Cutting Depth
1. The depth of cut can be set in millimetres by turning the depth control knob. (Diagram A)
2. The depth scale has lines representing millimetres. To set, align the bottom edge of the
depth control knob on a line and read off the number that is just completely exposed.
3. When cutting wood the depth of cut should be set to slightly greater than the thickness of
the material for best results.
4. When cutting plastics the depth of cut should be set to slightly greater than the thickness
of the material. If melting occurs a greater depth setting will improve results.
If it is desirable not to mark the surface beneath the workpiece, the depth can be set to
slightly less than the material thickness, when cutting wood or plastics, but this may result in
a rough edge.
NB. If the depth control knob becomes difficult to turn, unscrew it until the rubber seal can
be seen. Clean the surrounding area with a soft brush and then apply a very small quantity of
grease to the seal.
Blade Changing
NB. Incorrect positioning of the blade can permanently damage the tool.
1. Ensure the battery is disconnected from the tool.
2. Without removing the guard insert the U key into the blade shaft to lock it. (Diagram B )
Slide off the removable cover, insert the torx key into the blade retaining screw and unscrew
clockwise. (Diagram C)
3. Tilt the tool to remove the blade.
4. Insert the new blade through the slot and place onto the blade shaft ensuring the hole
locates correctly and the teeth point forwards in the direction of the curved arrow. (Diagram
C)
5. Replace the safety retaining washer and tighten the screw. (Diagram D)
6. Remove both keys before plugging in.
Guard Removal
NB. Do not use without the Guard. The guard should only be removed for cleaning.
1. Disconnect the battery
2. Depress the plunger with the tool provided. Slide off the guard. (Diagram E)
NB. When replacing the guard the blade can protrude through the slot in the base plate. To
avoid injury ensure that the hand is kept well clear. Ensure the guard is replaced the correct
way round.
3
www.romus.fr
Réf 93690
GB
©
Precision Tools Ltd. 2013
17
Publicité
