Hilti TE 30 Mode D'emploi Original page 15

Recommended minimum conductor gauge (cross section) and maxi-
mum cord length with 120V supply voltage
Extension cords
Extension cord conductor
gauge
Extension cord conductor
gauge
Extension cord length
Extension cord length
6 Operation
6.1 Preparations at the workplace
CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Unplug the supply cord before making adjustments to the power tool or
before changing accessories.
Observe the safety instructions and warnings in this documentation and on
the product.
6.1.1 Fitting the side handle
1. Release the side handle clamping band by turning the handle grip.
2. Slide the side handle clamping band over the chuck from the front and
into the recess provided.
3. Bring the side handle into the desired position.
4. Tighten the side handle clamping band by turning the handle grip.
6.1.2 Adjusting the depth gauge (optional)
1. Press the release button on the side handle.
2. Adjust the depth gauge to the desired drilling depth.
3. Release the release button.
4. Check that the side handle is securely attached.
6.1.3 Removing the chuck
CAUTION
Risk of injury. The depth gauge, if fitted but not used, might hinder the
operator.
▶ Remove the depth gauge from the product.
Set the function selector switch to the
changing the chuck.
1. Disconnect the supply cord plug from the power outlet.
*2143374*
AWG 16
1,31
mm²
2,58
kcmil
25 m
75 ft
2
4
2143374
AWG 14 AWG 12
2,08 3,31
mm² mm²
4,11 6,53
kcmil kcmil
30 m 50 m
100 ft 150 ft
3
"Chiseling" position for
AWG 10
5,26
mm²
10,4
kcmil
100 m
250 ft
English 9