Estia HWS-1501CSHM3-E Manuel D'installation page 11

AIR TO WATER HEAT PUMP SYSTEM
11.0
EN
12.0
The pace of product development is such that we reserve the right to change product
specifications without notice. We do, however, strive to ensure that all information in this
leaflet is accurate at the time of publication.
12
GUARANTEE
For warranty details please contact your ESTIA Heat Pump supplier.
This water cylinder is guaranteed provided that:
11.1 The unit has been installed in accordance with these instructions and all
necessary inlet controls and safety valves have been fitted correctly.
11.2 Any valves or controls are of the manufacturers recommended type.
11.3 The unit has not been tampered with and has been regularly maintained as
detailed in these instructions.
11.4 The unit has been used only for heating potable water (max. 250mg/l chloride).
11.5 The unit has not been subjected to high chloride levels in the water supply or
incorrect disinfection methods.
11.6 Following commissioning the unit is put into service within a period of 7 days.
If this is not the case it must either be drained or regularly flushed as required
in the section "Commissioning – Warning".
11.7 The unit is NOT guaranteed against damage by frost or due to build up of scale.
11.8 This guarantee does not affect the statutory rights of the consumer.
This guarantee DOES NOT cover the ESTIA Air to Water Heat Pump Outdoor
Unit or ESTIA Hydro Unit.
ENVIRONMENTAL INFORMATION
12.1 This product is manufactured from many recyclable materials. At the end of its
useful life it should be disposed of at a Local Authority Recycling Centre to
realise the full environmental benefits.
12.2 The insulation material is CFC/HCFC free expanded polyurethane foam with an
ozone depletion factor of zero.
INSTALLATION AND SERVICE MANUAL