OTHER FUNCTION OF RDS CODES
Auto GEQ function
The equalization curve is switched automatically to match the
music program type of an RDS station.
Press AG.
AG lights up.
To cancel, press it again.
GEQ matching PTY:
PTY
GEQ
POP M
POP
ROCK M
ROCK
LIGHT M
JAZZ
CLASSICS
CLASSIC
JAZZ
JAZZ
COUNTRY
POP
NATION M
POP
OLDIES
POP
FOLK M
JAZZ
Others
off
The selected GEQ can be changed to suit your preference by
pressing GEQ. During this time, the Auto GEQ function is
cancelled.
Clock-time (*
8
CT)
The CT function provides the unit with information about the local
time. The CT function works whenever a CT station is received.
If you have not set the clock (the clock flashes on the
display)
The current time can be set automatically by tuning in to an RDS
station.
If no RDS station is preset, tune in to an RDS(CT) station
manually by pressing f DOWN or g UP.
If the clock does not agree with the broadcast time
An RDS signal will update the clock time on the hour every hour.
*
5
Program type identification (PTY)
PTY allows selection of listening by one of 30 or more
program types rather than by a station.
*
6
Enhanced other networks information (EON)
EON information gives the receiver a cross reference to
other stations and allows the receiver to switch from the
currently tuned station to another RDS station.
*
7
Traffic program identification (TP)
This is a code which informs the receiver that a tuned
station regularly broadcasts traffic information.
*
8
Clock-time (CT)
CT function provides an accurate clock signal which is
self adjusting to time zones and seasonal time changes.
To change the MW tuning interval
The default setting of the MW tuning interval is 9 kHz/step. If you
use the unit in an area where the frequency allocation system is
10 kHz/step, change the tuning interval as follows.
Press POWER while pressing TUNER BAND.
To reset the interval, repeat this procedure.
When the MW tuning interval is changed, all preset stations are
cleared. The preset stations have to be set again.
En
13
ENGLISH