Profi Care PC-DVL 3071 Mode D'emploi page 26

English
26
• Do not repair the appliance on your own. Always contact an
authorized technician.
• This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental ca-
pabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance
in a safe way and understand the hazards involved.
• Children shall not play with the appliance.
• Cleaning and user maintenance shall not be made by children
without supervision.
• Do not immerse the device into water for cleaning. Please
follow the instructions as stipulated in the chapter "Cleaning
and maintenance".
Parts description / Scope of delivery
1 Spacer tube
2 Baldachin
3 Pre-installed fastening screws and spring washers
(6 pieces each)
4 Paper padding (3 pieces)
5 Pull chain for setting the power level
6 Mounting bar
7 Screws (M5*50), dowels, washers and retainer rings
8 Pull chain extension
9 Fan blade
10 Switch for setting the rotation direction (summer/winter
operation)
11 Motor housing
Unpacking the Device
1. Remove the device from its packaging.
2. Remove all of the packaging material such as foils, filling
material, cable holders and cardboard packaging.
3. Check the scope of delivery.
4. Check the appliance for any transport damage to prevent
a hazard.
NOTE:
There may still be dust or production residues on the sur-
face of the device. We recommend that you quickly wipe
off the housing with a damp cloth.
Assembly instructions
CAUTION:
• Important! The ceiling must be suitable to carry the
weight of the fan. Suspended ceilings are not suitable
for installation.
• Check beforehand for any cables hidden behind the
ceiling that could be damaged by installation!
WARNING: During installation
Switch off the home circuit breaker of the power supply line
to which to connect the device.
1. Chose a suitable spot on the ceiling, taking into consid-
eration the wingspread of the fan blades.
2. Remove two of the four pre-installed screws (A) from the
mounting bar (6). Loosen the other two screws half way.
3. There are two methods for attaching the mounting bar:
a) Wooden ceiling/beam: Attach the mounting bar us-
ing both long screws (M5*50) and the corresponding
washers and retainer rings.
b) Concrete ceiling: Mark the two positions in the slot-
ted holes using a pencil. Drill the installation holes for
the dowels. Insert the dowels into the holes. Attach
the mounting bar using both long screws (M5*50)
and the corresponding washers and retainer rings.