DURAVIT 791847 Notice De Montage Et D'utilisation page 6

Important information
Mounting instructions information
These mounting instructions come as part of the Duravit
bathtub and should be read carefully prior to installation.
Explanation of the key words and symbols
Is used to address practices not related
NOTICE
to physical injury.
Target readership and qualifications
The whirltub must only be installed by trained plumbing
engineers. The electrical installation should only be carried
out by qualified electricians.
Risk of product and/or property
NOTICE
damage!
> Observe the local installation regulations and any
country-specific standards at all times.
Mounting instructions
Please read pre-installation information sheets prior to
the installation. These are available to download on the
Internet at www.duravit.com.
Providing for an inspection hatch and air supply
Inspection hatch dimensions:
min. 30 x 30 cm
Provide an opening in the panel for the air supply with
an area of approximately 15 cm
2 x 7.5 cm).
6
ZU_M_LED white light below the bathtub edge/15.09.3
(z.B. 3 x 5 cm or
2
Operation
Information on the lighting function
Short contacts or spray water are overlooked in order
to prevent any unintentional restart. If the sensor
is actuated, a short interval of approx. 3 seconds is
therefore required before it will react to any further
actuation.
Remove water from the Duravit logo if applicable.
After 2 hours the light will switch off automatically.
Switching the white LED light on/off
> Touch the Duravit logo on the bathtub edge with the flat
of the hand.