FONESTAR AIP-1020 Mode D'emploi page 3

CONNECTION
- Connect the AIP-1020 microphone to the local area network via the ethernet port, RJ-45.
- Connect the device to the mains supply using the mains adapter provided.
CONFIGURATION
There are two ways of configuring the AIP-1020 microphone:
- via internet using the AIP-Go application.
- via an external configuration file generated by the AIP-Go application itself.
VIA INTERNET USING THE AIP-GO APPLICATION
In order to configure the parameters of the AIP-1020 microphone via the local area network, use the
AIP-Go application.
Download the instruction manual for the AIP-Go software from fonestar.com/AIP-Go and follow the
configuration instructions or access the Youtube channel: youtube.com/user/FonestarSistemas in which
the video is available explaining the configuration of the AIP-1020 microphone.
VIA THE CONFIGURATION FILE
The AIP-1020 microphone obtains an IP address automatically if the router has the DHCP option activated.
Otherwise, it must be assigned an IP address manually and all the necessary parameters for your data
network and operating of the device must be adjusted. When setting all these options, it is possible to
generate a file to configure the AIP-1020 microphone.
Execute the AIP-Go application and follow the steps below:
In the program options, select the option General> Advanced > Offline configuration.
1.- Activate/deactivate the option to change the
name.
2.- Write the name of the device to be configured.
3.- Allows network configuration change to be
activated/deactivated.
4.- Activate/deactivate DHCP configuration.
With the DHCP option deactivated, it is possible
to configure:
5.- The IP address of the AIP-1020 microphone.
6.- The subnet mask of the AIP-1020 microphone.
7.- The gateway of the AIP-1020 microphone.
8.- Allows the port range for the channel to be
changed.
9.- Enter the port range of the AIP-1020 microphone
to be configured or use the default option.
- 3 -
EN