Overview Of The Components - CTC CLATRONIC SPM 3754 Mode D'emploi

• Do not use the appliance in damp areas.
• Do not use a water jet when cleaning the appliance.
• This appliance is not intended for immersion in water during
cleaning. Please refer to the instructions provided in the chapter,
"Cleaning / Maintenance".
Designated Use
This appliance is intended for cleaning, waxing and pol-
ishing closed shoes or boots being worn by the user of the
appliance. It is not suitable for open shoes (e.g. sandals).
It is intended for domestic use and use of similar areas. It
may only be used in the manner described in this instruction
manual. The appliance may not be used for commercial
purposes.
Any other use is considered as not intended and may lead
to damage of property or even to personal injury.
The manufacturer assumes no liability for damage which
may occur through incorrect use.
Unpacking the Appliance
1. Take the appliance out of its packaging.
2. Remove all the packaging material such as plastic foil,
filling material, cable ties and cardboard packaging.
3. Check that all parts are supplied in the box.
4. In case of incomplete delivery or damage, do not operate
the appliance. Return it to your dealer immediately.
NOTE:
There may still be dust or production residues on the
appliance. We recommend to clean the appliance as
described under "Cleaning / Maintenance".

Overview of the Components /

Scope of Delivery
1 Housing
2 on / off switch
3 Recessed grip
4 Bracket for the polishing dispenser
5 Polishing dispenser
6 Closure of the polishing dispenser
7 Rubber mat
8 Polishing brush (right)
9 Cleaning brush
10 Polishing brush (left)
26
SPM3754_IM
Notes for Use
Location
Place the appliance on a non-slip, level surface.
Electric Connection
1. Before inserting the power plug into the outlet, check
that the mains voltage to be used matches that of the
appliance. You can find the required information on the
nameplate.
2. Connect the appliance to a properly installed earthed
socket.
Short-term Operation
Do not operate the appliance for longer than 10 minutes
and always allow the appliance to cool down for 5 minutes
thereafter.
Switching the Appliance On / Off
Turn the appliance on and off by using the
Filling the Polishing Dispenser
1. Unlock the bracket of the polishing dispenser by pressing
in the centre of the rear surface located on the left side.
2. Remove the bracket by pulling it sideways to the right.
3. Open the closure of the dispenser. Make sure that the
spring and the ball in the closure do not fall out.
4. Fill the dispenser with colourless, liquid shoe polish.
NOTE:
Suitable shoe polish is available, e.g., in well-known
online mail-order companies.
5. Place the closure, including its ball and spring, on the
dispenser and tighten it.
6. Reattach the bracket to the appliance with the dispenser
in place. To do this, insert the bracket on the right and
snap the surface into place on the left.
Using the Appliance
WARNING: Risk of injuries!
The use with open shoelaces or other loose parts on the
shoe is prohibited!
switch.
07.01.20