König Electronic HAV-MCS42 Mode D'emploi page 4

SETTING UP AND CONNECTING
Replacing the remote control's battery
The remote control's battery is already installed at
the factory. If the remote control stops operating,
replace the battery with a new one.
1. Squeeze the notched tab A while pulling the
battery door latch B out to take the battery holder
out.
2. Insert a "CR2025" 3V lithium battery. Make sure
the polarity (the + and – side of the battery) are
correct.
3. Place the battery holder back in the remote control.
Follow these precautions when using a battery in this device.
1. Use only the size and type of battery specified in this manual.
2. Make sure you install the battery according to the polarity indicated in the battery
compartment. Reversed polarity may cause damage to the device.
3. If the device is not going to be used for a long period of time, remove the battery
to prevent damage or injury caused by possible battery leakage.
4. Do not try to recharge the battery, it's not intended to be recharged and doing so
may cause the battery to rupture or leak.
Connecting speakers
1. To insert the speaker cable in to the connector,
push down the terminal lever of the connector and
put in the cable. Release the lever and the cable
will be clamped in the connector.
2. Make sure the cables are connected correct.
Connect the left speaker to the left terminal, and
the right speaker to the right terminal.
Connecting headphones
You can use headphones (not included) to listen in privacy. Insert the headphones'
3.5mm plug into the phones socket. Use corresponding adapters if you have different
plugs. The speakers will cut off automatically when the headphones are being connected
to the 3.5mm socket.
WARNING:
Excessive sound pressure from earphones and headphones can cause hearing loss.
BATTERY PRECAUTIONS
4
RED
BLACK
RED