Operation; Switching Flame Simulator On / Off; Using The Dimmer Function - CHICAGO AJ55C-LED Manuel D'utilisation

Operation

The voltage of the power source must comply with the specifications
on the name plate of the heater.
Devices marked with 230 V can also be operated with 220 V. Before
operation it is imperative to make sure that the installation location
corresponds to the requirements of the safety instructions.
Note: When the heater is turned on for the first time, a slight, harm-
less odour can develop. This odour develops due to the heating up of
the inner heating elements. Provide sufficient ventilation.

Switching flame simulator on / off

Note: You can also switch on the flame simulator when you are not
using the heating function.
Note: Power consumption of the electric fireplace insert with illuminati-
on switched on but without heating function amounts to approx. 2 W.
• Open the right hand cover 2 by opening it up towards the front.
• Set the ON / OFF switch 9 to position I.
• Set the ON / OFF switch 9 to position 0 if you would like to turn off
the flame simulator.
• Close the right hand cover 2.

Using the dimmer function

Note: Your electric fireplace insert has a dimmer function. With it you
can adjust the brightness of
the flame simulator.
Note: You can only use the dimmer function when the flame simulator
is switched on (see "Switching flame simulator on / off").
• Open the left hand cover 6 by opening it up towards the front.
• Turn the dimmer 11 in the direction of rotation to increase the
brightness of the flame simulator or as the case may be turn the
12