AKO 3710337 Mode D'emploi page 11

5. Technical data
Input voltage:
Output voltage:
Efficiency:
Charging voltage:
Charging current:
Ambient temperature:
Battery types:
Sound level:
6. Maintenance and repair
The device does not require maintenance, but should be thoroughly cleaned at regular intervals. In the event of a fault, the device must be
taken out of use immediately. Repairs must only be carried out following prior consultation with the manufacturer and be carried out by
a qualified electrician. Only use original spare parts.
Declaration of conformity
Albert KERBL GmbH hereby declares that the product / device described in these instructions complies with the fundamental requirements and other relevant stipulations
and regulations. The CE mark confirms compliance with the Directives of the European Union. The declaration of conformity can be viewed by visiting http://www.kerbl.de.
Electronic scrap
Disposing of this device after its service life is the responsibility of the operator. Please consult the valid national regulations. The device must not be disposed of in
household waste. In accordance with the stipulations of the EU Directive on the Disposal of Electrical and Electronic Devices, the device can be disposed of free of
charge at the local waste collection or recycling centre. Alternatively, it can be returned to retailers who offer a collection service. The proper disposal helps to ensure
environmental protection and prevents any adverse effects on human health and the environment.
120 V, 60 Hz or 230 VAC, 50 Hz 12 V & 24 V (automatic selection)
12 V and 24 V (auto-select)
> 75 %
14.3 V ± 0.3 V or 28.6 V ± 0.3 V
2 A/5 A/10 A for 12 V and 2 A/5 A for 24 V
-10 °C to + 40 °C (reduced output at higher temperatures)
12 V and 24 V lead-acid batteries (WET, MF, AGM and GEL)
< 50 dB (tested from a distance of 50 cm)