Publicité
Les langues disponibles
Les langues disponibles
VE150 Cooling Unit
Before starting up the unit, read this instruction manual carefully, store it and pass it on the next
customer if the unit is resold.
WARNINGS
-
Failure to follow instructions may cause damage and/or injury
-
This unit may not be used for purposes other than those described in this manual.
GENERAL SAFETY
-
The unit must only be installed by qualified personnel.
-
If the unit shows visible signs of damage, do not operate it.
-
The unit must only be repaired by specialised personnel (Indel Webasto Marine Service
Centres). Repairs performed inadequately could cause damage and/or injury.
-
Under no circumstances open the cooling circuit.
-
Install the unit in a dry place, protected from any splashes of water and direct sunlight.
-
Do not place the unit near naked flames or other heat sources (heating, direct sunlight, gas
ovens etc.).
-
Ensure that the cooling unit (compressor) is sufficiently ventilated.
-
The unit must be stored and/or installed out of reach of children.
-
Before operating the unit, ensure that the operating voltage and the battery voltage match.
-
In order to connect to the main electricity supply, use protection systems and/or a circuit
breaker (∆I 0.03 A).
-
If the connecting cable is damaged, it must be replaced with a cable that has the same
technical specifications (cross-section and length).
-
For general cleaning of the unit, never use detergents containing sandy substances, acids or
solvents.
-
Protect the unit from rain and moisture.
-
Before connecting the quick charger, disconnect the main power supply to the unit.
-
Never touch any exposed and/or damaged wires with bare hands.
-
Disconnect the unit from the mains when not in use for long periods.
-
The batteries may contain aggressive acidic and corrosive liquids. Ensure these do not come
into contact with eyes/skin.
14
Publicité
