Basic Operation; Restoring Factory Default Settings - Esoteric D-05 Manuel Du Propriétaire

Basic Operation

1
Turn the unit on.
The ring surrounding the button lights when the unit is on.
< Also turn on all devices connected to the unit.
< When the master clock (MCK) is set to WORD IN, "WRD
UNLOCK!" or "NO WORD" will appear on the display when
the unit is turned on as a word signal cannot be detected as
soon as the unit is powered up. These messages vanish
when the word signal is locked.
2 Press the INPUT button to select an input.
Each press of the button changes input and the selected
input appears on the display.
DUAL (Dual AES input using two XLR terminals)
RCA
OPT
i.LINK
XLR1
XLR2
< When 2 XLR cables are connected and a Dual AES signal is
being received, choosing XLR1 causes only the left channel
to be output as monaural and choosing XLR2 causes only
the right channel to be output as monaural.
Play back the source after selecting the source.
The text on the display flashes when a digital signal is not
detected. Turn on the connected device and check made
connections.
< The INPUT buttons (</>) on the remote control unit of the P-
05 can also be used.
< The remote control unit of the P-05 can also perform
VOLUME adjustment (–/+) and MUTING.
Press the POWER button to turn off the unit after use.
10

Restoring factory default settings

If you have made a lot of changes to the setup, and want to
restart from a known set of options, restore the unit to the
factory settings as follows:
1. Turn the unit off and wait 30 seconds or longer.
2. Press the POWER button while holding down the MENU
button.
Release the MENU button when "Setup CLR" appears on the
display.
All memories are erased, and the unit returns to the factory
settings.