Alustar; Assembly Instructions - EINHELL ALUSTAR Instructions De Montage

Notes on use / baseplate / baseplate diagram
Notes on use
• Check the screw connections and retighten as necessary
every three months.
• Check the screw connections and tight seating of the
web panels after gusty winds or a storm.
• Close the windows and doors of your greenhouse during
heavy winds or a storm.
• You should additionally secure the greenhouse using a
suitable storm anchoring device (not supplied) in areas
subject to increased storm activity.
• Do not strike the web panels with hard objects at
temperatures below the freezing point (0 °C/32 °F).
• The roof of your greenhouse must be freed of snow in
good time in order to avoid a dangerous amount of weight
from building up. Even 10 cm of snow or 2 cm of ice can
be dangerous!
• The roof of your greenhouse is not designed to be
walked on!
• Do not start an open fire or similar in the greenhouse!
Use only approved heating units!
• Observe the local building ordinance.
Baseplate diagram
Concrete or masonry baseplate
Greenhouse
AluStar I
AluStar II
AluStar III
h
10 cm
Outside
s
Concrete /
brickwork
base
4
La (cm) Li (cm)
151 131
221 201
291 271
The base must be at
least 100 mm wide
and 300 mm high.
The base must be
dead level, with
perfectly square
corners.
Ensure that there is
sufficient space (s)
between the bore
holes and the edge
of the internal base.
Baseplate
Important: The greenhouse does not have an additional
baseplate profile. You can erect your greenhouse on a
previously prepared masonry or concrete baseplate (see
baseplate diagram) or you can assemble it on an
aluminium base. (Available as accessories: Aluminium
base for AluStar I, art. no. 36.406.40; AluStar II, art. no.
36.406.41; AluStar III, art. no. 36.406.42).
Also available as special accessories are anchoring sets
BD4-SET (4 ground anchors), art. no. 36.405.90 and
BD6-SET (6 ground anchors), art. no. 36.405.91.
Important:
!
If you do not want to erect your greenhouse on
a masonry or concrete baseplate, ensure that
your greenhouse is built on level, sturdy ground.
Check levelness using a water level!
Baseplate of concrete/masonry
Perpendicularity of the baseplate is very important when
erecting the greenhouse. The baseplate must be at exact
right angles and level. Check the latter using a water level.
Important: The baseplate must be sunk to the frost-
penetration depth.
Ba (cm) Bi (cm)
221 201
221 201
221 201
Ba
La
Note on assembly instructions:
!
The 3-field model (AluStar II) serves as a reference model in
the assembly instructions.
This model is shown in the respective overview illustrations.
The other houses differ from this model
only by the number of side fields.
T (cm) H (cm)
10 Frost-penetration depth
10 Frost-penetration depth
10 Frost-penetration depth
Bi
Li
H
T