Changing A Transceiver's Battery; Mode Of Operation - Bodet LoRa Notice D'installation Et D'utilisation

2.4 Changing a transceiver's battery

Battery
rating

3. mOdE Of OPEraTiON

Each mode is set using the Sigma software (see the relevant manual).
We recommend the 'ON' mode. Several simultaneous pushes can trigger the Lockdown Alert System non stop.
The Lockdown Alert System transceiver allows you to:
>
start or stop the melodies or alerts manually,
>
activate / deactivate the relays,
>
activate / deactivate the programmes.
All the actions from the transceiver transmit via the Sigma master clock.
8
1) Open the transceiver: Unscrew the screw on the back of the
transceiver then carefully separate the two sides.
2) Remove the electronic card.
3) Remove the used battery from its housing.
4) Slide the new battery in to its place being careful to match the
polarity.
5) Replace the electronic card with the new battery in the box.
The fixing plates and the dimensions of the electronic card mean
that it must be correctly reassembled.
6) Reclose the box and fasten the screw (stage 1).
EN