Pairing And Deactivation Of Transceivers - Bodet LoRa Notice D'installation Et D'utilisation

diPs position
SW1 SW2 SW3
* refer to the drawings of scenarios 1 and 2 to see the placement of the connectors linked to the Sigma master clock.
** refer to the illustration of the transceiver below to see the number of keys on the transceiver.

2.3 Pairing and deactivation of transceivers.

>
Pairing a transceiver
1) Press briefly on the push button
2) Watch for the red LED to flash
3) Press one of the transceiver keys.
4) Check that the red LED
5) The transceiver is paired.
>
deactivate the transceivers
CauTiON: all transceivers paired with the receiver will be deactivated. it is not possible to deactivate each
transceiver individually.
1) Press briefly on the push button
2) press on the push button
3) Watch for the red LED flashing
4) The transceivers are not linked to the receiver.
independent or shared relays*
Relays Independent
1
Relays Shared
2 3
Relays Independent
4
Relays Independent
1
Relays Independent
2
Relays Shared
3 4
Relays Independent Key 1 closes the relay
1 2 3 4
B
on the receiver.
L
on the receiver.
L on the receiver remains lit for several seconds.
B
on the receiver.
B on the receiver until the red LED goes out
L on the receiver for a few seconds before turning itself off.
Transceiver actions**
Key 1 closes the relay
1
Keys 2 or 3 close the relays
Key 4 closes the relay
4
Key 1 closes the relay
1
Key 2 closes the relay
2
Keys 3 or 4 close the relays
1
Key 2 closes the relay
2
Key 3 closes the relay
3
Key 4 closes the relay
4
L on the receiver.
EN
2 3
3 4
7