Care & Maintenance; Cleaning; Storing; Resetting The Motor Thermostat - Ninja BN600C Série Guide De L'utilisateur

USING THE REVERSIBLE
SLICING/SHREDDING DISC – CONT�
NOTE: Before slicing or shredding,
prep your ingredients. Refer to the
Food Prep section in the Quick Start
Guide for more information.
5 Press the Power button to turn it on,
then select DISC or LOW. Add the
prepped ingredients you want to slice or
shred through the feed chute on the lid.
Use the food pusher to help guide the
ingredients through the feed chute.
6
If using the Auto-IQ® program, DISC,
the disc will automatically stop
spinning at the end of the program. If
using the manual program LOW, press
the button again, and wait for the unit
to come to a complete stop.
7
To remove the lid, press the button on the
feed chute lid near the handle to unlock,
then turn the lid counterclockwise. Lift the
lid from the bowl.
12 ninjakitchen.com
8
Using the finger holes, carefully lift the
disc out of the bowl. Then, grasp the
spindle by the top of the shaft and lift it
out of the bowl.
9 To remove the bowl from the motor
base, turn the bowl counterclockwise
and then lift it up.
10 Press the Power button to turn the unit
off, then unplug the unit. Refer to the
Care & Maintenance section for cleaning
and storage instructions.
CARE & MAINTENANCE

CLEANING

Separate all parts. Wash bowl in warm,
soapy water with a soft cloth.
• Hand-Washing
Wash bowl, lid, disc, and blade assemblies
in warm, soapy water. When washing
the blade assemblies, use a dishwashing
utensil with a handle to avoid direct hand
contact with blades.
Handle blade assemblies with care to
avoid contact with sharp edges. Rinse
and air-dry thoroughly.
• Dishwasher
All attachments are dishwasher safe. It
is recommended that the bowl, lid, disc,
and blade assemblies be placed on the
top rack of the dishwasher ONLY. Ensure
the blade assembly is removed from the
bowl before placing in the dishwasher.
Exercise care when handling blade
assemblies.
• Motor Base
Turn off the unit and unplug the motor
base before cleaning. Wipe motor base
with a clean, damp cloth.
DO NOT use abrasive cloths, pads, or
brushes to clean the base.

STORING

Wrap the power cord around the cord
wrap on the back of the motor base.
Store the unit upright and store all blade
assemblies inside or attached to the bowl
with the lid locked in place.
DO NOT stack items on top of the
containers. Store any remaining
attachments alongside the unit or in a
cabinet where they will not be damaged
or create a hazard.

RESETTING THE MOTOR THERMOSTAT

This unit features a unique safety system
that prevents damage to the motor and
drive system should you inadvertently
overload the unit. If the unit is overloaded,
the motor will be temporarily disabled.
Should this occur, follow the reset
procedure below.
1 Unplug the unit from the
electrical outlet.
2 Allow the unit to cool for approximately
15 minutes.
3 Remove the bowl's lid and blade
assembly. Empty the bowl and ensure
no ingredients are jamming the blade
assembly.
IMPORTANT: Ensure that maximum
capacity is not exceeded. This is the most
typical cause of appliance overload.
If your unit needs servicing, call Customer
Service at 1-877-646-5288. So we may
better assist you, please register your
product online at registeryourninja.com
and have the product on hand when
you call.

ORDERING REPLACEMENT PARTS

To order additional parts and attachments,
visit ninjaaccessories.com.
ninjakitchen.com 13