Features; Manual Programs; Using The Blade Assemblies - Ninja BN600C Série Guide De L'utilisateur

FEATURES

Use the Power button to turn the unit on and off.
AUTO-IQ®
Intelligent preset programs combine unique processing and pausing patterns that do
the work for you. Once an Auto-iQ program is selected, it will start immediately and
automatically stop when processing is complete. To stop processing before the end of
a program, press the currently active button again
NOTE: Program run times vary from a few seconds up to a minute.
AUTO-IQ PROGRAMS
CHOP
Timed pulses and pauses give you
consistent chopping results. Run
program once for a large chop, twice
for a small chop and three times if you
prefer to mince.
PUREE
(Not available on all models)
Create anything from silky-smooth
sauces to the perfect hummus.

MANUAL PROGRAMS

LOW and HIGH
When selected, each of these speeds
runs continuously for 60 seconds. They
do not work in conjunction with any
preset Auto-iQ programs.
IMPORTANT: DO NOT run the unit on
HIGH if using the dough blade.
IMPORTANT: The unit is NOT intended
to crush ice. Refer to the warnings on
pages 4-6.
8 ninjakitchen.com
DOUGH
Ideal for creating delicious dough,
from pie to pizza to cookie doughs.
NOTE: Use PULSE to add mix-ins, such
as chocolate chips or raisins, after
dough program has completed.
DISC
Slice or shred a variety of ingredients,
from fresh vegetables to cheeses.
PULSE
Offers greater control of pulsing and
processing. Operates only when PULSE is
pressed. Use short presses for short pulses
and long presses for long pulses.

USING THE BLADE ASSEMBLIES

IMPORTANT: As a safety feature, if the
blade assembly is not fully seated, you
will not be able to install and lock the lid
in position.
NOTE: DO NOT add ingredients before
completing installation of the blade
assembly.
NOTE: Please follow the same instructions
to install the Dough Blade Assembly.
1 Place motor base on a clean, dry, level
surface such as a countertop or table,
then plug in the unit.
2 Lower the Precision Processor
TM
Bowl onto the motor base and rotate
clockwise until it clicks into place.
3 Exercising care, grasp the Chopping
Blade Assembly by the top of the shaft
and place it onto the drive gear inside
the bowl. Note that the Chopping
Blade Assembly will fit loosely on the
drive gear.
4 Add ingredients to the bowl, making
sure not to exceed the 2.1 L (9-cup) line.
5 Place the feed chute lid on the bowl
and turn clockwise until you hear a click,
indicating the lid is locked in place. The
control panel will stop flashing, indicating
the bowl and lid are properly assembled.
ninjakitchen.com 9