Programming; Programming The Remote-Receiver; Programming The Awning - weinor BiRec MVLED Instructions De Montage

Programming

5
5.1

Programming the remote-receiver

The system is usually supplied pre-programmed. Therefore, when the system is
delivered, all the components can be controlled with the hand transmitter supplied. On
rare occasions or if servicing has been carried out, however, the system will need to be
programmed on site. This is done by pairing up the hand transmitter and remote-receiver
and setting them to various functions.
5.2

Programming the awning

In the case of receivers that have already been electrically installed, briefly disconnect the
1.
power supply immediately before programming.
2. Start programming mode: within 5 minutes of disconnecting the power supply, press the
LEARN key (1) for 2 seconds on the hand transmitter. The remote-receiver then enters
programming mode for about 2 minutes. During this time, the awning moves up for 4
seconds and then down for 4 seconds.
3. Immediately after the awning starts moving up (within the first second), press the
key on the hand transmitter. The receiver confirms the command by briefly stopping the
awning and then moving it up further. If the receiver does not confirm the command, simply
repeat this step on one of the next cycles.
4. Immediately after the awning starts moving down (within the first second), press the
DOWN key on the hand transmitter. The receiver confirms this step by leaving programming
mode; the sun protection stops moving.
5. If integrated lighting is connected to the BiRec MVLED/MLED, the light programming mode
will start automatically. Now program the light by taking the following steps. For designs with
no light, stop programming mode by pressing
the STOP key.
BiConnect BiRec MVLED/MLED
Assembly and installation instructions/ Instructions de montage et d'installation
We reserve the right to make technical changes/ Sous reserve de modifications techniques
1
Version 4
Item number/
Numéro d'article 116692-0000 Page 9/28
UP
2020-07-08