Operation - weinor BiRec MVLED Instructions De Montage

3.3

Operation

To switch the hand transmitter channel, see the hand transmitter operating
instructions.
The BiRec MVLED/MLED remote-receiver has been pre-set in the factory to perform the following
functions when used together with a hand transmitter:
Channel 1 = Awning and Valance Plus
•
Channel 2 = Light
•
• Channel 3 = Other component (optional)
The table below describes the factory default settings.
Channel/Component Component
1 Awning and
Valance Plus
(BiRec MVLED only)
2 or 3 Light or other
component
Table 1: BiRec MVLED/MLED remote-receiver functions
BiConnect BiRec MVLED/MLED
Assembly and installation instructions/ Instructions de montage et d'installation
We reserve the right to make technical changes/ Sous reserve de modifications techniques
Briefly press DOWN key
Briefly press DOWN key
BiRec
MVLED only
Briefly press UP key
Press STOP key
Press and hold UP/DOWN
key
or
Press and hold UP/DOWN
key
or
Press STOP key
Function
- Awning extends completely
- Valance Plus then extends
(to sun protection position)
Valance Plus retracts completely, then
awning retracts automatically
Stop
Switch on light
Control dimming
Switch off
Version 4
Item number/
Numéro d'article 116692-0000 Page 7/28
2020-07-08